Basic Operation; Charging The Speaker - KlipXtreme Oryx KBS-600 Manual Del Usuario

Components
Carrying string for easy transport
1. Lanyard
Once unit is ON, press this button to change
2. Power/Mode button
between Bluetooth® mode and Aux mode.
Note: You will be able to change modes only if a
device is connected to Aux In in the speaker.
In order to adjust the volume level, briefly press the
3. Volume up+/Next track button
button.
Press and hold the
In order to adjust the volume level, briefly press the
4. Volume down-/Previous track
button.
button
Press and hold the
track.
Briefly press this
5. Play/Pause/Answer call/End call/
Briefly press this button to answer an incoming call or
Redial/Multi-function button
end the call.
Press and hold this button to reject the call.
Press this button twice to call back the last number
dialed on your phone.
Note: Audio will stop and resume automatically once
the call is ended.
Press and hold this button to release Bluetooth
6. Bluetooth release button
®
connection.
Use this input to connect any external audio device
7. AUX IN cable connection
fitted with a 3.5mm stereo output.
interface
Description
button to play the next track.
button to play the previous
button to play or pause audio.
8. Micro-USB charging port
9. Power LED indicator
10. Microphone location
11. Bluetooth ® LED indicator
12. Battery LED charge indicator
III. Basic operation
A. Charging the speaker
• Plug one end of the supplied Micro-USB cable into the speaker's Micro-USB port and the
other end to the USB port of a 5VDC USB adapter to charge the battery.
• The battery takes around 4 hours to fully charge.
• Make sure that the speaker is fully charged before using it for the first time.
• While the speaker is being charged the power LED indicator glows red with the speaker on or
off.
• Power LED glows red and the battery indicator LED's individually flash when the speaker is on.
®
• Power LED turns Off and the battery indicator LED's lit up solid once it is fully charged when
the speaker is on.
Note: If the speaker is completely discharged or has not been charged for a while, it is
recommended to charge it for at least 10 minutes prior to powering on the speaker.
Use this Micro-USB connector to connect to
an external 5VDC power source
This LED indicates power status
Microphone location
This LED indicates the status of the Bluetooth
connection.
This LED indicates the charging status of the
speaker while it is powered on.
Note: if the speaker is off, then only the
Power LED will be active.
®