Advanced Operation - KlipXtreme Oryx KBS-600 Manual Del Usuario

B. Turning the speaker units on or off
• To turn on the speaker, press and hold the Power
• The Bluetooth indicator LED will turn on and you will hear a tone. The Bluetooth
®
will momentarily turn on, then flash indicating that is ready for pairing mode or become
solid once it is paired to a device.
• Press and hold the Power button again for 2 seconds to turn off the speaker. The
LED will turn off and you will hear an audio tone.
Bluetooth
®
C. Using the speaker in Auxiliary mode
• Connect one end of the 3.5mm stereo cable into the auxiliary port on the speaker.
• Proceed to connect the other side of the 3.5mm stereo cable into the media device of
choice, such as a laptop, MP3/4 player, smartphone or tablet.
• Turn on the speaker. The Speaker will automatically connect to Aux in, and you will hear
a prompt.
• If it doesn't connect, briefly press the power button on the speaker to select the Aux in
mode or the mode of choice.
• Select the input mode of choice using the source button on the unit.
• Play an audio file to listen to music.
IV. Advanced operation
Note: Before installing this product, please make sure your device has the built-in Bluetooth
feature available.
A. Pairing the speaker with your mobile device in Bluetooth
1. Turn on the speaker.
2. Set your Bluetooth phone to "discover" the wireless speaker.
®
button for about 2 seconds.
LED
®
®
mode
®
3. The Bluetooth indicator LED will start blinking to indicate that the device has entered into
®
the pairing mode and is ready to be detectable for the first time.
4. Tap the newly discovered audio device (KBS-600) displayed on your mobile phone, in
the Bluetooth list.
®
5. If you have a lower Bluetooth version, you may be prompted to enter the passkey 0000
®
(4 zeros).
6. If pairing is successful, a tone will be heard, and the LED light will turn solid blue. If after 60
seconds the pairing process fails, please repeat steps 1 through 6 described above.
7. We recommend turning off the device when not in use. The speaker will shut off
automatically after a period of inactivity, as long as it is not in the Bluetooth
Note: The speaker will connect to Bluetooth
connection.
B. Pairing the speaker with your mobile device in TWS mode
1. Power on the two KBS-600 speakers and make sure they are both in pairing mode.
2. Press and hold the Multi-function button
your master unit) for approximately 4 seconds or until you see the Bluetooth
blinking on the second unit (a tone will also be emitted). Once you hear the tone, TWS
pairing was successful.
Note: the master unit will remain in pairing mode.
3. Release the multi-function button once the TWS pairing has successfully paired both
speakers, as per previous step.
4. Follow section A above to connect the master speaker to Bluetooth
C. Unpairing speaker from TWS mode
Briefly press the power button on the master unit, the Bluetooth
will start blinking (a tone will also be emitted). Once you hear the tone, TWS un-pairing
was successful.
mode.
®
automatically if the device supports automatic
®
on one of the units (this one will become
LED stops
®
®
LED on the second unit
®