Klarstein THERMAXX ELEVATE SMART Manual Del Usuario página 17

Caution: Danger of Scalding.
Do not touch the heater during operation. The housing will become hot.
When the power cord is plugged in and the switch is not pressed, the product enters
standby state: the power lights are highlighted, the other 5 lights are low, and the digital
tube is not displayed.
ON/Standby (all items)
1. Press the "on" button to start the machine. If no other operation is carried out, the
default mode will be the high-end mode (the default temperature is 24 °C). The
mode key will be highlighted and the middle digit of the digital tube will display "3".
2. Click the on key again and the product enters standby state.
3. The machine functions as a switch under normal conditions, and remembers the
status before shutdown (timing function does not remember) when the machine is
not switched off.
Modes
1. In the starting state, press this key to switch to the heating mode of the machine, and
the fi rst power on will default to high-grade (the default temperature is 24 °C). The
switching sequence is high → medium → low → high...Loop, the middle digit of the
three-digit digital tube shows "3→2→1→3..."Cycle.
2. Can also be activated and highlighted when the mode is set, and click ∧/∨ to
increase or decrease the tap
3. During and after setting the mode, the indicator light in the middle of the mode key
will be highlighted, the middle digit of the digital tube will show the current set gear,
and the digital tube will show room temperature 3 seconds later.
Timer
1. Press the timing key to enter the timing shutdown setting. The indicator light in the
middle of the timing key is highlighted. The time content is displayed by the three-
digit digital tube.
2. Adjust time by clicking ∧/∨, auto confi rm after 5 seconds without operation or
directly click timing key to confi rm, (maximum setting is 24h, 0h is no timing).
3. No matter what heating mode the machine is in, it can be set to shut down
regularly.
4. During and after the timing setting, the indicator light in the middle of the timing
key will be on high (when the timing is set to 0, that is, when there is no timing, the
timing indicator will be on low);
5. After timing confi rmation, the digital tube displays the timing shutdown time within 3
seconds, and the digital tube displays room temperature after 3 seconds.
EN
17