UFESA CC2000P Manual De Instrucciones página 21

Do not pull on the connection cord in order to unplug it or use it as a handle
Unplug the product immediately from the mains in the event of any breakdown or damage and contact
an official technical support service. In order to prevent any risk of danger, do not open the device. Only
qualified technical personnel from the brand´s Official technical support service may carry out repairs
or procedures on the device.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for the
non-observance of these warnings.
INSTALLATION
1,8m
20cm
20cm
Drill two holes in wall and have a distance of 1.8m from the ground. The diameter of the hole just con-
tained the inflated plastic pipe. After tucked the inflated plastic pipe, fixed pothook on the pipe with screw.
Make sure pothook fastness and hang the heater. The clip under the pothook should be inserted rabbet
of the heater bottom.
Function operation (both machine & remote control):
1. Plug in and switch on by pressing the red switch 0/I, enter into standby mode and display shows (fig 1)
2. Press" " button for one time, enter into fan mode and the display show "--"(photo A) . Press second
time , the product works in low heating and display shows like photo B Press third time, changes to high
heating and display shows like photo C , then Press fourth time , enter into in standby mode and display
shows"--"like photo A. the cool fan will work for 30seconds and enter into standby mode. (Figuer 2)
3. Press " " button to set timer(00-12hours). Pressing the button one time increases one hour for
timer. After setting time, the display will show current setting time for 5 seconds, then resume to previous
display, meanwhile the light of " " will on. Below photo is an example of setting 8h: (Figure 3)
4. Appointment "ON": In standby mode, press " " timer button, you can set the appointment turn-on
time in 1-12 hours. After complete setting, the display shows the appointment turn-on time and also the
light " " is on. The display automatically decreases 1 hour for each hour passed. When the appointment
power-on time arrived, the product will automatically turns on. The default setting temperature is 23 ºC
during appointment turn-on. Below photos is an example to set appointment turn-on time to 8 hours:
21