Baldwin Prestige Serie Instrucciones De Instalación

TEMPLATE PLANTILLA
Prestige Series
Handlesets Installation Instructions
1. Adjust and install latches
Measure your door and prepare using template if needed.
Deadbolt
If backset of door
measures 2 3/4"
(70mm), adjust
latch by rotating
face as shown.
Note, for a 1-1/2" (38mm) diameter hole,
/ 2 "
E
test if latch extends and retracts. Chisel
U R
5 1
A S
T out area if required.
M E S E
C K
B A
Ensure the latch is
inserted with the word
"UP" on top.
Install latch with
11/16" screws.
2. Install trim
Spindle
Make sure the curve of half round spindle
corresponds to the opening in the latch; if
it does not, reverse the handing as follows:
(1) Pull spindle away from mechanism, (2)
rotate it 1/2" turn (180°) and release.
3. Install knob / lever
Place lever or knob onto assembly and tighten set screw to secure.
4. Install and adjust strike
Adjust tang as needed.
www.baldwinprestige.com
Latch
If backset of door measures 2-3/4"
(70mm), adjust latch shown by
grasping the spring pin and moving
it to the 2-3/4" slot.
Install latch with 11/16" screws.
Make sure the slant of the latch bolt
faces in the direction that the door
closes.
See drilling template
for hole location.
1/8" pilot holes may be required.