Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION: Hook Mount
STEP 1: Screw the hook into the fixture,
tighten and secure.
STEP 3: Connect wires using the
wiring diagram and instructions on
page 1. Make sure connections are
capped and sealed.
INSTALLATION: Ceiling Mount
STEP 1: Use a pen or sharp tool and mark holes
through the mounting surface on the ceiling and drill
holes. Fix screws into the holes with a hammer.
STEP 3: Connect wires using the
wiring diagram and instructions on
page 1. Make sure connections are
capped and sealed.
Optional DC Motion Sensor
Motion sensor installation does
not require tools.
NOTE: The motion sensor
has no dialing code. A remote
control (86/219) is needed
for adjustment. Refer to
remote control instructions
for adjustments. Maximum
mounting height for sensor is
39 feet, 4 inches (12 meters).
CCT & Wattage Selectable Functions
Fixture has three integrated CCT selectable and
Wattage selectable functions.
OPERATION: Take away the water-proof gasket,
adjust dip switch to choose CCT and Wattage as
desired. CCT is factory preset to 4000K. Wattage
is preset to the highest level.
© Copyright 2020 Satco Products, Inc. 12/20
STEP 2: Hang the
fixture on the ceiling
hook or chain.
STEP 2: Align the bracket hole with screw hole
and push the fixture to one side and secure.
NOTE: By adjusting the bracket screws,
the fixture can be angled 50° to the left or
right vertically.
If motion sensor is
not desired, unscrew
the motion sensor
and replace it with a
protective cover.
2
Satco Products, Inc.
Brentwood, NY 11717
Publicidad
