Satco NUVO 65-251 Instrucciones De Instalación Y Seguridad

LED CUTOFF WALL PACK & CUTOFF WALL PACK
WITH EMERGENCY BATTERY BACKUP
Models: 65-251, 65-252, 65-253, 65-254, 65-255, 65-256,
65-257, 65-258, 65-259, 65-260, 65-261, 65-262
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
Risk of Fire or Electric Shock
• To reduce the risk of fire, electrical shock or injury to persons; read and follow all warnings
and installation instructions before installing.
• All installation should be performed by a qualified electrician.
• To avoid electric shock, ensure power is turned off before installation or inspection.
All wiring must be installed in accordance with Electrical Code and local electrical code.
• To prevent fire, this fixture is rated for use in 100-277V, 50-60Hz protected circuit and
90°C rated supply wire.
• To prevent product malfunction and/or electrical shock, this product must be properly
grounded.
• To avoid damage and/or product malfunction, do not modify the fixture or replace
accessories without confirming with the supplier first.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal
or other sharp objects.
• Suitable for wet locations.
IMPORTANT:
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the product and the hazards involved.
INSTALLATION: Junction Box to Wall
STEP 1: Open the fixture by untightening the screws.
STEP 2: Disconnect the quick connect terminal.
STEP 3: Drill 4 holes at bottom of fixture and paste
the EVA gasket.
STEP 4: Loosen the plug on the fixture, then thread
input wires through the opening. Screw the bottom
cover with junction box to the wall.
STEP 5: Connect the wire with power input line by
3 connectors, refer to wiring diagram.
(L = Black, N = White, G = Yellow/Green).
STEP 6: Reconnect the quick connect terminal.
Close the fixture and tighten with the screws.
INSTALLATION: Mounting Kit to Wall
Follow STEPS 1 and 2 (see above).
STEP 3: Choose a mounting position according to your
requirements. Loosen the plug on the fixture and fasten
waterproof connector to opening. Rotate the mounting
kit to the proper angle.
STEP 4: Mark the 3 holes needed for the mounting
kit on the wall, then drill holes. Install rubber plugs into
holes, then fasten the fixture to the wall using screws.
STEP 5: After installing the bottom plate, thread input
wires through the opening and tighten the screws on
the connector.
STEP 6: Connect the wire with power input line by
3 connectors, refer to wiring diagram.
(L = Black, N = White, G = Yellow/Green).
STEP 7: Reconnect the quick connect terminal.
Close the fixture and tighten with the screws.
© Copyright 2019 Satco Products, Inc. 2/19
1
3
3
4
Dimensions
362mmW x 250mmH x 238mmD
2
Quick Connect
Terminal
4
WIRING DIAGRAM
L = Black
N = White
Light Fixture
G = Yellow/Green
Satco Products, Inc.
Brentwood, NY 11717