Satco NUVO 65/710 Instrucciones De Instalación Y Seguridad

LED DUAL HEAD
SECURITY LIGHT
Models: 65/710, 65/712, 65/714, 65/716, 65/718, 65/720
Models with Optional Motion Sensor: 65/711, 65/713, 65/715, 65/717, 65/719, 65/721
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Commercial installation, service and maintenance of luminaries should be
performed by a qualified licensed electrician. If you are unsure about the
installation or maintenance of the luminaries, consult a qualified licensed
electrician and check your local electrical code.
• Turn OFF power at fuse or circuit breaker before wiring fixture to power supply.
• Turn OFF power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label.
• Risk of Burn. Disconnect power and allow fixture to cool before handling.
• Clean glass lens with non-abrasive glass cleaning solution.
• Do not open fixture to clean the LED. Do not touch the LED.
WIRING: If wiring does not include a ground wire, consult your local electrical
code for approved grounding methods. For proper connection, place wire nut
over wires and twist clockwise until tight.
1. Connect supply wires. Use wire nut to connect the black fixture wire to the
black power supply wire and the white fixture wire to the white (neutral) supply
wire. NOTE: Lamp heads must be positioned above motion sensor head and
controls on motion sensor must face the ground.
2. Aim lamp heads and install optional visors. Loosen knobs and aim lamp heads.
CAUTION: Risk of Shock: Aim lamp heads at least 20º down below horizontal
in order to prevent water from accumulating inside lens. After lamp heads are
positioned as desired, align the optional visor over the front of the lamp head
and secure by tightening set screw on visor.
3. Weatherproof gaskets and junction box with silicone sealant, tighten all screws.
INSTALLATION: Wall Mount (External Junction Box)
STEP 1: Disconnect power supply.
Remove (2) plastic plugs. Remove
inserted screws and mounting plate.
STEP 4: Connect the wires, refer
to the Wiring Diagram.
© Copyright 2020 Satco Products, Inc. 8/20
STEP 2: Attach junction box on
the wall (not supplied).
Mounting
Plate
STEP 5: Secure fixture onto mounting
plate with screws, replace plastic plugs.
(2) M5*18
Screws
(2) Plastic
Plugs
1
Optional
Motion Sensor
WIRING DIAGRAM
Fixture
STEP 3: Fix mounting plate
and gasket onto junction box.
Gasket
STEP 6: Check fixture and
connect power supply.
Satco Products, Inc.
Brentwood, NY 11717