Use For Children From 40 To 105 Cm; Setting The Groowy Up For Rear Facing Installation; Installation Of The Safety Seat In The Car; Fastening The Child In The Seat - JANE GROOWY i size Manual De Instrucciones

USE FOR CHILDREN FROM 40 TO 105 CM

F. SETTING THE GROOWY UP FOR REAR FA-
CING INSTALLATION
• To save space, in its original packaging the GROOWY seat is
set up for forward facing installation. The seat needs to be ro-
tated 180 degrees on its base before installing it in the vehicle.
1
.a
• On the bottom of the base there is a red lever that releases
the rotation mechanism of the seat. Press it and turn the seat
to the next locking position.
• Unfold the leg fully.
G. INSTALLATION OF THE SAFETY SEAT IN THE
CAR
• The ISOFIX anchors (6) are automatically extracted by firmly
pulling both the red rings (9) found on the front of the base.
1
.c
• In some vehicles, the ISOFIX anchors are difficult to access
or they are hidden between the foam sections of the vehicle
seat. With the seat we have provided some guides (19) making
it easier to locate them, insert them before the following step.
• Guide the anchors towards the axles in your vehicle and press
until both sides are locked into place. Two green signals on the
front of the base (8) will show that they are securely anchored.
44
EN
1
.b
If one or both of the signals are red, try again.
• Press the base (1) against the backrest of the vehicle.
• Release the lock for the leg by sliding the button (9a) to the
right. Extend the leg until it touches the floor of the vehicle. Lift
the seat until the button (9a) locks again and the green signal
is shown in the window of the button (9a) and on the base of
1
the leg (9b). .e
• When using the NEST baby carrier in the vehicle it must always
be attached to the GROOWY safety seat in the rear facing
position using the exclusive JANÉ Pro-fix anchors.
H. FASTENING THE CHILD IN THE SEAT
WITH THE NEST BABY CARRIER (FROM 40 TO 65 CM)
• Loosen the integral seat belts by pulling the straps (23) above the
buckle while pressing the strap tightening button (23b).
• Unfasten the buckle (23a).
• Place the baby in the baby carrier making sure that he is sit-
ting as far back as possible. Bring the upper ends of the buc-
2
kle together. .c
• Insert them into the fastener and press until you hear them
2
click locked. .d
• Pull the tightening strap (23b). The correct strap tension is very
important for the child's safety, do not leave the straps too loose.
2
.e
• Position the baby carrier on the safety seat lining up the Pro-
1
.d
2
.a
2
.b