Levelling; Electrical Connection - Domus DMP30136 Manual De Uso Y Mantenimiento

3.1.3. Levelling.

-Do not anchor the machine; just put it on a flat and levelled surface. Position the 4 adjustable feet
supplied and found inside the machine on the tray. A good levelled base is important for correct
operation.
Procedure:
-Adjust the 4 levelling feet to ensure the stability and horizontality of the machine, checking it with a
spirit level on the two sides of the machine (see following figure). After adjusting, fasten the nut
using a spanner.
-The maximum adjustment height at the height of the levelling feet is 25 mm.
3.2.

Electrical connection

Make sure that the characteristics of the available power supply correspond to those of your ironer,
indicated on its identification plate, and that the cable section and other line accessories can supply the
necessary power.
The machine leaves the factory with the complete electrical installation, and therefore you will only have
to remove the cover on the back of the ironer and connect each of the terminals to the three phases L1,
L2, L3 and neutral N to the terminals of the general switch. Before leaving the factory the ironing
machine is tested observing the cyclical direction of phases L1-L2-L3 (A1-A2-A3) (R-S-T). This direction
must be observed in order not to damage the appliance.
23