A Foot Panel Position - ubabub Nifty Instrucciones

A
Foot panel position
Step 1 Clear floor space.
Step 2 lay Nifty end on the ground screw holes facing up. Using screw driver insert
Connecting Pins to the six points as per diagram.
Step 3 Insert support Pins, next to single connecting pin at top of the end Panel .
Step 4 repeat on other end.
Step 5 Place the end with Connecting Pins up on a carpeted surface or blanket
to protect the end.
Step 6 Insert lower rails (with legs) onto Connecting Pins. ensure the holes for
the locking Cams are facing towards the inside of the crib, align the
corresponding dots
(see Fig.01).
Step 7 Insert locking Cams on both lower rails.
Step 8 align the locking Cams and connecting pins. Insert the connecting pins to
the lower rails. Make sure connecting pins are passing through the locking
Cams. Insert the locking Cam nuts. Use screwdriver to turn locking Cam nuts
clockwise until tight. (see Fig.02).
Fig. 02
2.1
Insert the
connecting pins
to the rails.
2.3
Use screwdriver to turn locking
Cam nuts clockwise until tight.
10
2.2
Insert the
locking Cam
nut.
Fig. 01
align corresponding
dots at each end of
all components.