How To Use; Auto Shut-Off - UFESA GS1700 Manual De Instrucciones

Plancha vertical
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
STEAMER WITH WATER
Press the 2 buttons at the same time to remove the water tank and pull out the water tank.
Remove the water inlet stopper. Fill the water tank with a maximum of 220 ml of untreated tap water.
Your appliance was designed to operate using untreated tap water.
Do not use pure demineralised or pure distilled water, water from clothes dryers, scented or softened
water, rain water, filtered, bottled or boiled water, water from refrigerators, batteries or air conditioners as
these may damage the appliance. These types of water contain organic waste, mineral elements that
become concentrated when heated and cause spitting, brown staining, leaking or premature wear on
your appliance. If your water is very hard, mix 50% untreated tap water with 50% distilled water.
Close the water inlet stopper.
Return the water tank to its place on the appliance then plug it in.

HOW TO USE

Before the using please check the fabric´s label for recommendations.
We recommended that you test acrylic, nylon or other synthetic fabrics in an inconspicuous area to
ensure these fabrics are not damaged by hot steam.
Use a clothes hanger to iron your clothes.
Plug-in the appliance, a blue light will twinkle on the base. Turn it on by pressing the on/off switch. A red
light will twinkle on the button and the blue light on the base will change to bright. Wait until the light stop
twinkling and change to bright, meaning you can use the high power steam (approximately 20 seconds).
Press again and the light will change to blue, for smaller power steam. If pressed again the product will
stop operating and the blue light will twinkle on the base. Once selected the higher or lower power steam
you can use the product by pressing the steam button.
Press the steam button with the steam brush facing away from you holding it in a vertical position. For
optimal use, pass the steam jets over your garment from top to bottom.
As steam is very hot: never attempt to remove creases from a garment while it is being worn, always
hang garments on a clothes hanger.
The fabric brush opens the weaves of the fabrics for better steam penetration. Before removing or
attaching the steam brush, unplug your appliance and allow it to cool down.
During use or while unit is heating or cooling do not rest appliance on its head. Place the product on a
stable, heat resistant, flat surface, as the head will be hot. As the appliance heats, the housing becomes
warm. This is normal.
Remove the main plug from the wall socket. Wait for an hour for your appliance to cool before storing.

AUTO SHUT-OFF

This product is fitted with an automatic switch-off system. This stops the product from heating up if it is
resting on its base and is not moved for about 8 minutes.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido