Screw Cover - Sterling 6065 Guia De Instalacion

Top
Track
Bumper
Insert
Wall
Jamb
Screw
Inside of
Bath
10. Install the Bumpers and Screw Covers
Install the Center Jamb Bumper
Run a #8 x 3/8" self drilling screw through a bumper insert.
Insert a screw into the pre-drilled hole in the center jamb and tighten.
Place a bumper on each bumper insert in the vertical position.
Rotate the bumper so the Sterling logo is upright.
Install the Screw Covers
Install a screw cover over each of the eight exposed screw heads on the wall jamb and column
assembly.
1035946-2-B
Outside
of Bath
Bottom Track
#8 x 3/8" Self-Drilling
Screw
Screw
10
Screw
Cover
Sterling