Craftmade Bellows Duo Guia De Instalacion página 9

9. Handheld Remote Control Assembly.
Gently pull on remote control cover to separate top
and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote
control, cut each wire on wall control --use wire
cutters to cut off each wire as close to the wall
control as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall control.
[Refer to diagram 2.]
Since this fan comes with an LED light kit, the
dimmer switch (labeled DIM and ON) has been
pre-set to the "ON" position (DIM). If you do not wish
to have dimming capability, please move the switch
to the "OFF" position (ON). [Refer to diagram 2.]
Attach black faceplate to front of wall control; press
down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and press
together firmly. Place wall control into BOTTOM part
of remote control cover, aligning posts in top of
remote control cover with post holes in the bottom.
[Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and
bottom of remote control cover together until you
hear a click at each end, indicating that the remote
control cover has closed completely.
IMPORTANT: Store the handheld remote control
away from excess heat or humidity. To prevent
damage to handheld remote control, remove the
battery if handheld remote control will not be used
for long periods.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK." - When
disposing of household alkaline batteries, it is best to
check with your local and state recycling or
household hazardous waste coordinators
concerning the specifics of the program in your area.
You may also locate a recycling center by calling
1-800-8-BATTERY or 1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
diagram 1
diagram 2
post
hole
remote control
cover, BOTTOM
diagram 3
page 9
remote
control
cover
(top)
(bottom)
wall control
dimmer
wire
switch
- 1 1
-
2 2
DIM ON
wire
wire
12V battery
hole
-
1 1
- 2 2
DIM ON
face-
plate
wall
remote control
control
post
cover, TOP