Shure INTELIMIX P300 Guia Del Usuario página 5

Ocultar thumbs Ver también para INTELIMIX P300:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
Get More Information
Now that the basic setup is complete, you should have access to the web
application and be able to pass audio between devices. More comprehen-
sive information is available online and in the help section, including:
• Maximizing audio quality with the built-in parametric equalizer
• External control system command strings
• Signal routing
• System scenario diagrams
• Software configuration
• Networking information
• Troubleshooting
• Replacement parts and accessories
The complete user guide is available at http://pubs.shure.com/guide/P300
USB Computer System
Computer
input
output
control
RF
audio
gain
power
A
B
ULXD4
OL
ENTER
OL
Digital Wireless Receiver
EXIT
IR
SCAN
push
Wireless Microphone
Powered
System
Loudspeaker
1. Connect the computer to the USB port on the P300
2. Connect a powered loudspeaker or amplifier to the P300 analog
output 2. In the matrix mixer, this is labeled Analog - To Speaker.
3. Connect additional analog sources (such as wire-
less microphones) to the P300 analog input 2.
4. In the P300 web application, open the matrix mix-
er to make connections between devices.
Note: Some connections are established in the matrix mixer by default. Refer to
the matrix mixer help topic in the web application for additional information.
Required Matrix Mixer Connections:
Input
Output
Automix
USB output
Analog input 2
USB output
USB input
Analog - To Speaker
5. In the schematic view, right-click any AEC block and set
the AEC reference channel to Analog - To Speaker.
6. In the web application, adjust input and output lev-
els and perform a sound check. Refer to the help top-
ics in the web application for additional information.
usb
Network Switch
MXA310
(PoE+ Required)
Hardware Codec System
control
RF
audio
gain
power
A
B
ULXD4
OL
OL
Digital Wireless Receiver
ENTER
EXIT
IR
SCAN
push
Wireless Microphone System
1. Connect the hardware codec audio output to the P300 analog in-
put 1. In the matrix mixer, this is labeled Analog - From Codec.
2. Connect the hardware codec audio input to the P300 analog out-
put 1. In the matrix mixer, this is labeled Analog - To Codec.
3. Connect a powered loudspeaker or amplifier to the P300 analog
output 2. In the matrix mixer, this is labeled Analog - To Speaker.
4. Connect additional analog sources (such as wire-
less microphones) to the P300 analog input 2.
5. In the P300 web application, open the matrix mix-
er to make connections between devices.
Note: Some connections are established in the matrix mixer by default. Refer to
reset
the matrix mixer help topic in the web application for additional information.
Required Matrix Mixer Connections:
Input
Automix
Analog input 2
Analog - From Codec
6. In the schematic view, right-click any AEC block and set
the AEC reference channel to Analog - To Speaker.
7. In the web application, adjust input and output lev-
els and perform a sound check. Refer to the help top-
ics in the web application for additional information.
5
Video Codec
input
output
usb
Network Switch
Loudspeaker
(PoE+ Required)
Output
Analog - To codec
Analog - To Codec
Analog - To Speaker
reset
MXA910

Publicidad

Tabla de contenido
loading

Tabla de contenido