Troubleshooting - Dirt Devil SD20000RED Manual De Usuario

TROUBLESHOOTING

WARNING
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below.
This product contains no serviceable parts. Call 1-800-321-1134 for Customer Service.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call customer service at
1-800-321-1134 prior to continuing use.
PROBLEM
Cleaner
won't run
Cleaner won't
pick up or low
suction
Dust escaping
from cleaner
NOTICE
AN INTERNAL THERMAL PROTECTOR HAS BEEN DESIGNED INTO YOUR CLEANER TO
PROTECT IT FROM OVERHEATING. WHEN THE THERMAL PROTECTOR ACTIVATES THE
CLEANER WILL STOP RUNNING. IF THIS HAPPENS PROCEED AS FOLLOWS:
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Empty dirt cup.
3. Inspect the nozzle and bag inlet openings for any obstructions. Clear obstructions if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner needs servicing.
12
To reduce the risk of personal injury - Unplug before cleaning or servicing.
POSSIBLE REASON
1. Power cord not firmly plugged into
outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
4. Thermal Protector activated.
1. Dirt cup not installed correctly.
2. Dirt cup full.
3. Brushroll worn.
4. Broken or worn belt.
5. Clogged filter.
6. Nozzle/brushroll clogged.
7. Hose clogged
1. Dirt cup full
2. Dirt cup not installed correctly.
3. Hose not installed correctly.
4. Filter not installed completely.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace fuse
reset breaker.
3. Call Customer Service: 1-800-321-1134.
4. Allow cleaner to cool for 30 min.
1. Review dirt cup removal & replacement.
2. Empty dirt cup.
3. Replace brushroll.
4. Replace belt.
5. Remove filter and clean.
6. Check nozzle/brushroll; remove obstruction/clog.
7. Remove hose and tools; remove obstruction.
1. Empty dirt cup.
2. Review dirt cup removal & replacement.
3. Review hose installation.
4. Review filter removal & replacement.