Satco NUVO 65/710 Instrucciones De Instalación Y Seguridad página 2

INSTALLATION: Wall Mount (Built-in Junction Box)
STEP 1: Disconnect power supply.
Remove (2) plastic plugs. Remove
inserted screws and mounting plate.
STEP 4: Secure fixture onto
mounting plate with screws.
(2) M5*18
Screws
INSTALLATION: Ceiling Mount
STEP 1: Disconnect power supply.
Remove (2) plastic plugs. Remove
inserted screws and mounting plate.
STEP 4: Connect the wires, refer
to the Wiring Diagram.
TROUBLESHOOTING
1. Check your power source.
2. Check electrical connections.
STEP 2: Drill (4) holes on the wall and
insert expansion screws. Attach gasket
and fix mounting plate with screws.
Mounting
(4) M4*30
Plate
Screws
(4) M4
Flat Gasket
STEP 5: Replace plastic plugs.
(2) Plastic
Plugs
STEP 2: Attach junction box on
the wall (not supplied).
Mounting
Plate
STEP 5: Secure fixture onto mounting
plate with screws, replace plastic plugs.
3. Check that the photocell or motion sensor
is working properly (if so equipped).
Gasket
(4) Expansion
Screws
Gasket
(2) M5*18
Screws
2
STEP 3: Connect the wires,
refer to the Wiring Diagram.
STEP 6: Check fixture and
connect power supply.
STEP 3: Fix mounting plate
and gasket onto junction box.
STEP 6: Check fixture and
connect power supply.
(2) Plastic
Plugs