Location Requirements; Choose The Proper Location - Kenmore 796.8127 Serie Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KEY DiMENSiONS
AND SPECiFiCATiONS
Description
Dryer (Gas and Electric)
Electrical Requirements
Refer to the rating labet
Gas Requirements _ NG:
4-10.5
inches WC (Water Column)
Gas Requirements _ LP:
8-13 inches WC
Dimensions
27 in. (W) X 30 1/4in. (D) X 38 in. (H), 52 1/4 in. (D with door open)
68.6 cm (W) X 76.7 cm (D) X 96.5 cm (H), 132.7 cm (D with door open)
Net Weight
Electric : 147 lb. (66.7 kg) Gas : 150.5 lb. (68.3 kg)
Drying Capacity
IEC 7.3 cu. ft.
_Gas Models Only
LOCATION
REQUIREMENTS
Standard
Installation
- Side View
iMPORTANT:
Read att installation
instructions
completely
before
installing and operating
your dryer,
i
It is important
that you review this entire manual before
2o 1/8in.
installing and using your dryer. It contains detailed
(56.2 cm)
instructions concerning
electrical
connections,
gas
connections
and exhaust requirements.
CHOOSE
THE PROPER LOCATION
* Store and install the dryer where it witl not be exposed
to temperatures
below freezing
or exposed to outdoor
weather
conditions.
* Choose a location
with a solid, level floor.
*If the dryer is being installed in a garage,
place the
dryer at least 18 inches (45.7cm)
above the floor.
* Properly ground the dryer to conform
with all
governing
codes and ordinances.
* To reduce the risk of electric
shock, do not install the
dryer in damp or wet locations.
iMPORTANT:
If you are installing
your
dryer
in a
manufactured
or mobile
home,
please
refer
to the
Special
Electrical
Requirements
for Mobile
or
Manufactured
Homes
section.
CLEARANCES
* Most installations
require a minimum 5 1/2 inch (14 cm)
clearance
behind the dryer for the exhaust ducting.
* Allow minimum
clearances
of at least 1 inch (2.5 cm)
on the sides and back to minimize vibration
and noise.
* Allowing
additional
clearance
for installation
and
servicing
is recommended.
Be sure to allow for wall, door, or floor moldings that
may increase the required
clearances.
* Allow at least 21 inches (53.3 cm) in front of the dryer
to open the door.
Standard
Installation
- Front View
oJo
in.
cm)
l in.
l in.
(2.5 cm)
27 in.
(2.5 cm)
(68.6 cm)
m
J
3"
(7.6 cm)
_
Vent
48 sq. in. --
(310 sq. cm.)
Vent
24 sq. in.
(155 sq. cm.)
y
-
3"
_
(7.6 cm)
0
Additional
instructions
for closet installations:
The closet door must allow for sufficient airflow. Refer to the
diagram
above for minimum vent opening requirements. A
louvered door is also acceptable.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

796.9127 serie

Tabla de contenido