Tools And Parts; Location Requirements - Kenmore 110.84422610 Manual De Uso Y Cuidado

Tools and Parts

Tools needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
Flat-blade screwdriver
Level
Adjustable wrench that
opens to 1" (25 mm) or
hex head socket wrench
Parts supplied
Remove parts package from the dryer drum. Check that all parts
listed are included.
Cycle control knob
Casters (4)
Parts needed
Check local codes, existing electrical supply and venting,
and see "Venting Requirements" and "Electrical Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system
■
hardware.
For information on ordering, please refer to the back cover. You
may also contact the dealer from whom you purchased your dryer.
4
Tin snips (new vent installations)
Vent clamps
Caulking gun and
compound (for installing
new exhaust vent)
Start button
Cord brackets (2) and
screws (2)

Location Requirements

You will need
A location that allows for proper exhaust installation.
■
See "Venting Requirements."
A 120-volt, 60 Hz, AC-only, 15- or 20-amp circuit.
■
A grounded electrical outlet located within 2 ft (610 mm)
■
of either side of the dryer. See "Electrical Requirements."
A sturdy floor to support the dryer weight (dryer and load)
■
of 115 lbs (52 kg). The combined weight of a companion
appliance should also be considered.
A level floor with a maximum slope of 1" (25 mm) under
■
entire dryer.
Do not operate your dryer at temperatures below 45°F (7°C).
At lower temperatures, the dryer might not shut off at the end
of an automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
Installation Clearances
The location must be large enough to allow the dryer door
to open fully.
Dryer Dimensions
* Most installations require a minimum 5½" (140 mm) clearance
behind the dryer for the exhaust vent with elbows. See "Venting
Requirements."
Front View
*20 / "
3
4
(527 mm)
31"
(787 mm)
1 / "
3
4
23 / "
7
8
(44 mm)
(606 mm)