Bumper Insert; Screw - Kohler Sterling 6065 Manual Del Usuario

Wall Jamb Fully
Engaged with
Bottom Track
Bottom Track
4. Install the Wall Jambs
NOTE: When the wall jambs are properly positioned, the slots will be on the bath side of the wall jamb.
The slots should also be positioned away from the wall, closer to the door.
Secure the storage side wall jamb to the wall with three #8-18 x 1-1/2" panhead screws.
Secure the second wall jamb to the wall with two #8-18 x 1-1/2" panhead screws located in the
upper and lower installation holes.
Run a #8-18 x 1-1/2" screw through a bumper insert, insert the screw in the middle installation hole,
and tighten.
IMPORTANT! Do not apply caulk or sealant to the bottom track at this time.
NOTE: When positioning the bottom track, make sure the track extension is positioned on the storage
column side of the installation.
Position the bottom track assembly on the threshold.
Slide the bottom track assembly to each side until both ends are flush against the wall jambs.
Sterling
Track
Extension
Wall Jamb
Wall Jamb

Screw

Bumper
Insert
7
#8-18 x 1-1/2" Screw
Screw
Slots go toward
the inside of bath.
Screw

Bumper Insert

Screw
Inside of Bath
Screw
Outside of Bath
Bottom Track
Storage Side
Wall Jamb
1035946-2-C