Kohler 23665 Guia De Instalacion

Installation Guide
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
TOOLS AND MATERIALS NEEDED
Phillips & Flathead
Screwdriver
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto a
clean and soft cloth to protect finish. Confirm all parts are included.
2. Hold fixture (E) on to wall in desired mounting position ensuring that
canopy (N) will align with the junction box and mounting plate (K),
mark the anchor holes of plate (B) on the wall, take down fixture (E)
and plate (B). Next drill marked anchor holes with 1/4" diameter
masonry drillbit for concrete ceiling or 3/8" diameter drillbit for
drywall ceiling.
3. Insert suitable anchor (A) into drywall or concrete wall. Attach plate (B)
onto wall with screws (C).
4. Attach mounting plate (K) onto junction box with screw (L).
5. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture green or bare ground wire to the green or bare copper wire in
outlet box with wire nut (I) or fasten onto ground screw (J) on
mounting plate.
6. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture white wires to the white wire in outlet box with wire nut (I).
Wrap the wire connector with electrical tape so that the tape seals the
end of wire nut (I), see diagram.
7. NOTICE: To avoid short circuit, make sure wires are not exposed. Fasten
fixture lead wire without ridge(s) or black wire to the black wire in
outlet box with wire nut (I). Wrap the wire connector with electrical
tape so that the tape seals the end of wire nut (I), see diagram.
8. Press together the two connectors (M).
9. Tuck wires carefully inside outlet box. Attach the canopy (N) onto wall then secure it with screws (O).
10. Attach fixture (E) onto wall, secure it on plate (B) with set screws (D).
11. Install shades (F) and cages (H) onto fixture (E) with socket rings (G).
12. NOTICE: Do not exceed recommended wattage. Install lamp(s). Rated Max 60 W, Type G16.5. (Bulb(s) not included).
13. Adjust shade direction by loosening knurled nuts (P), adjusting shade angle to desired direction, and
then securing knurled nuts (P).
14. Restore power to circuit at breaker or fuse box.
CLEANING
Please clean fixture with a soft and dry cloth ONLY.
USA/Canada: 1-800-4 KOHLER
www.kohler.com
Please see next page for a larger installation image
Slip Joint Small Adjustable
Pliers Wrench
Wire Electrical
Cutter/stripper Current Tester
I
J
K
A
L
B
C M
D
N
E
O
P
F
G
H
Approved fastener
(Wire nut)
SKU#23665
Allen Wrench
Electrical
Tape
Electrical tape
1411464_2