Kohler 23669 Guia De Instalacion

Installation Guide
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
TOOLS AND MATERIALS NEEDED
Phillips & Flathead
Screwdriver
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put them onto
a clean and soft cloth to protect finish. Confirm all parts are included.
2. Attach mounting plate (C) onto junction box with screws (D). Ground
screw (B) is as shown.
3. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture green or bare ground wire to the green or bare copper
wire in outlet box with wire nut (A) or fasten onto ground screw (B)
on mounting plate.
4. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture white wire to the white wire in outlet box with wire
nut (A). Wrap the wire connector with electrical tape so that the tape
seals the end of wire nut (A), see diagram.
5. NOTICE: To avoid short circuit, make sure wires are not exposed.
Fasten fixture lead wire without ridge(s) or black wire to the black
wire in outlet box with wire nut (A). Wrap the wire connector with
electrical tape so that the tape seals the end of wire nut (A), see
diagram.
6. Press together the two connectors (E).
7. Tuck wires carefully inside outlet box. Attach the canopy (H) onto
mounting plate (C) with screws (G).
8. NOTICE: Product will operate with or without liquid. Pour distilled
water or reverse osmosis water at room temperature into the glass
(J). Do not fill glass globe to the top as it may result in glass
breakage. Fill globe to 1" below top of glass or use indicator line on
the attached sticker as a guide. Failure to follow instructions will void
the warranty and will create a safety hazard.
9. Install ruber washer (I), (K) and shade (J), with socket sleeve (L).
10. NOTICE: Do not exceed recommended wattage. Install lamp(s). Rated Max 60 W, Type G16.5. (Bulb(s) not included).
11. Restore power to circuit at breaker or fuse box.
CLEANING
Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild soap.
USA/Canada: 1-800-4 KOHLER
www.kohler.com
Please see next page for a larger installation image
Slip Joint Small Adjustable
Pliers Wrench
Wire Electrical
Cutter/stripper Current Tester
H
I
J
K
L
Approved fastener
(Wire nut)
SKU#23669
Electrical
Tape
G F E D C B A
M
Electrical tape
1411468_2