Kohler 23668 Guia De Instalacion

Installation Guide
PREPARATION
1. Record your model number for future reference.
2. DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before
beginning the installation procedure.
3. DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.
4. Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.
TOOLS AND MATERIALS NEEDED
Phillips & Flathead
Screwdriver
FIXTURE INSTALLATION
1. Remove the fixture and parts bag(s) from the carton. Put
them onto a clean and soft cloth to protect finish. Confirm
all parts are included.
2. Attach mounting plate (C) onto wall with screws (D).
Ground screw (B) is as shown.
3. NOTICE: To avoid short circuit, make sure wires are not
exposed. Fasten fixture green or bare ground wire to the
green or bare copper wire in outlet box with wire nut (A)
or fasten onto ground screw (B) on mounting plate (C).
4. NOTICE: To avoid short circuit, make sure wires are not
exposed. Fasten fixture white wire to the white wire in
outlet box with wire nut (A). Wrap the wire connector with
electrical tape so that the tape seals the end of wire nut
(A), see diagram.
5. NOTICE: To avoid short circuit, make sure wires are
not exposed. Fasten fixture lead wire without ridge(s) or
black wire to the black wire in outlet box with wire nut (A).
Wrap the wire connector with electrical tape so that the
tape seals the end of wire nut (A), see diagram.
6. Press together the two connectors (E).
7. Tuck wires carefully inside outlet box. Attach the canopy (G) onto
mounting plate (C) with mounting screws (F).
8. Install shade (H) and cage (I) onto canopy (G) with socket ring (J).
9. NOTICE: Do not exceed recommended wattage. Install lamp(s). Rated
Max 60 W, Type G16.5. (Bulb(s) not included).
10. Restore power to circuit at breaker or fuse box.
CLEANING
Please clean fixture with a soft and dry cloth ONLY.
USA/Canada: 1-800-4 KOHLER
www.kohler.com
Please see next page for a larger installation image
Slip Joint Small Adjustable
Pliers Wrench
Wire Electrical
Cutter/stripper Current Tester
G
H
I
J
Approved fastener
(Wire nut)
SKU#23668
Electrical
Tape
F E D C B A
Electrical tape
1411467_2