Record your model number:
Noter le numéro de modèle :
1464462-2
Anote su número de modelo:
CAUTION: Risk of personal injury. Do not install where the product
might be used as a grab bar or support bar.
IMPORTANT! When possible, secure the product to a wall stud.
1A. Drill Bits: 1/8", 1/4", 5/16"
2A. Recommended Tissue Holder Location: H = 8" (203 mm) to 12" (305 mm),
W = 6" (152 mm)
3A. Two-Post Accessory: Verify that "X" on the template matches your
product dimension.
4A. Some Models: Loosen the setscrew and remove the wall plate.
7A. For installation to a stud, drill 1/8" holes. For installation to drywall, drill
5/16" holes. For installation to ceramic tile, drill 1/4" holes.
8A. Installation Between Studs: Use the provided pin to install the drywall
anchors.
9A. Installation to Concrete or Tile: Install ceramic anchors.
Need help? Contact our Customer Care Center.
• USA/Canada: 1-800-4KOHLER (1-800-456-4537) Mexico: 001-800-456-4537
• Service parts:
kohler.com/serviceparts
• Care and cleaning:
kohler.com/clean
• Patents:
kohlercompany.com/patents
This product is covered under the KOHLER ® Faucet Lifetime Limited
Warranty, found at kohler.com/warranty. For a hardcopy of warranty terms,
contact the Customer Care Center.
ATTENTION : Risque de blessures. Ne pas installer ce produit dans
un endroit où il pourrait être utilisé comme barre d'appui ou barre de
support.
IMPORTANT! Lorsque possible, fixer le produit sur un montant mural.
1A. Mèches : 1/8 po, 1/4 po, 5/16 po
2A. Emplacement recommandé pour le distributeur de papier : H = 8 po
(203 mm) à 12 po (305 mm), l = 6 po (152 mm)
3A. Accessoire pour deux montants : Vérifier que le « X » sur le modèle
correspond à la dimension du produit en question.
1464462-2
A
-
1
A
4
A
1
2
A
H
W
5
3
X
A
X
6
Kohler Co.