Kohler K-1695 Guia De Instalacion página 9

Pitch toward
generator.
Steam Head
Drain/Spill Pan
Do not run pipes
down and then up.
3. Install the Piping
WARNING: Risk of scalding. Do not plumb a trap, shut-off valve, or pressure relief valve into the
steam line. Plumbing the pressure relief valve into the steam line can be hazardous, if the steam
outlet is capped.
WARNING: Risk of scalding. Do not locate the steam head near a seat or bench or scalding may
occur upon contact with the steam head.
NOTE: Follow the instructions packed with your steam head and user interface control.
IMPORTANT! The steam heads must be installed at least 6" (15.2 cm) from the floor in the shower/steam
room in an area where contact with occupants is unlikely.
IMPORTANT! Provide clearance between the back wall and the elbows. The elbows should not contact
the back wall.
NOTE: The edge of each hole should be at least 1" (2.5 cm) away from all wall studs.
Drill a 2-1/2" (6.4 cm) diameter hole in the wall at the desired steam head locations.
NOTE: For all the connections, use thread sealant tape and do not overtighten the fittings.
Connect 1/2" NPT copper pipe or copper tubing and a 1/2" copper union to the steam outlet of the
steam generator.
IMPORTANT! Never run the steam lines down, then up. Running the steam lines down and then up will
create a steam trap, blocking the flow of steam. Each steam lines should run up to the steam head from
the generator, at a pitch of 3/8" (1 cm) to 1/2" (1.3 cm) per 12" (30.5 cm) of pipe.
IMPORTANT! Never run the steam lines perfectly horizontal. Each line should contain a pitch of 3/8" (1
cm) to 1/2" (1.3 cm) per 12" (30.5 cm) of pipe, running up from the steam generator to the steam head.
Kohler Co.
Provide clearance
from wall.
Steam Trap
9
1" (2.5 cm)
Min
6" (15.2 cm)
from Floor
2-1/2"
(6.4 cm)
Wall Stud
1060226-2-D