Kohler K-5250 Manual Del Usuario página 7

5. Secure the Fixture
CAUTION: Risk of personal injury. Overtightening can cause
vitreous china to break or chip.
Place the washer and cap nut over the anchoring stud, and
carefully tighten to secure the drinking fountain.
From the bottom of the access, install the copper supply tube
with the compression fitting between the stop and control valve.
Connect the straight end of the tube to the stop, then connect the
angled end of the supply tube to the control valve until both are
hand-tight.
Secure both nuts with a wrench.
NOTE: The copper supply connection may be bent slightly to fit.
Snap the strainer plate into the strainer body. If necessary, adjust
the drinking fountain head so that the arc of the water is parallel
to the wall.
6. Install the Cover Plates
Check for leaks.
Install the cover plates to the bottom access openings.
Kohler Co. 7 101024-2-AC