Complete The Installation - Kohler K-5250 Manual Del Usuario

Bonnet
Assembly
Setscrew

7. Complete the Installation

When this drinking fountain is installed with a water cooler, jam
the knurled locknut against the bonnet assembly to prevent
continuous flow.
The lever handle has been adjusted at the factory so that the
blade is parallel to the floor. If additional adjustment is required,
remove the setscrew with a 3/32" hex wrench.
Pull the handle straight off. Do not twist the handle.
Reverse this procedure to reinstall the handle.
101024-2-AC
Knurled
Locknut
8 Kohler Co.