Care And Cleaning - Glacier bay F1AA0005OB Guía De Instalación Y Cuidado

Care and Cleaning

To clean, wipe down with a damp cloth and towel dry.
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
Hot and cold are reversed.
There is no or a low water
ow.
There is leaking or dripping
from the spout.
There is only hot water or only
cold water from the spouts.
Water comes out of the show-
erhead during tub ll mode.
The temperature range is
restricted.
Unable to install the handle or
the handle rubs against the
escutcheon.
The handle is hard to turn.
Lines reversed or cartridge
installed upside down.
One or both water supplies are
not turned on.
Grommets not sealing properly.
Balancing spool stuck.
The pipe used between the
valve and tub spout is not the
1/2 in. IPS nor COPPER pipe is
incorrect.
The distance between the valve
and the showerhead is less than
46 inches.
There are too many elbows or
something else that is restrict-
ing the ow of water exiting the
valve.
There is a restriction between
the valve and the tub spout.
The valve is installed upside
down.
The handle (more common in
knob models) is installed upside
down.
Temperature limit stop is out of
position.
The valve is installed too far
back from the nished wall.
The cartridge stem is dif cult
to rotate.
12
Rotate the cartridge stem 180°
so that the notch is facing down
towards the drain.
Turn both water supply valves
counterclockwise to the on
position.
Replace the cartridge.
Replace the cartridge.
Change the pipe to IPS or COP-
PER.
The distance from the shower-
head and valve moved to at least
46 inches.
Change or remove anything
restrictive.
Remove the tub spout and ush
out debris and/or replace the
undersized line or ttings.
Remove the valve and reinstall it
using the correct orientation.
Remove the handle, rotate it 180°
and re-install.
Reposition the temperature limit
stop to the desired temperature
position.
Order extension kit (206416676
or 206416670) on Homedepot.
com.
Replace or lubricate the car-
tridge.