Troubleshooting - Ego Power+ CS1400E Manual Del Operador

TROUBLESHOOTING

WARNING:
Always protect your hands by wearing heavy gloves when performing any maintenance on the saw chain.
Always remove the battery pack when servicing or transporting the chain saw.
PROBLEM CAUSE
The battery pack is not attached to
the chain saw.
There is no electrical contact between
the saw and battery.
The battery pack is depleted.
The battery pack or chain saw is
too hot.
The lock-off button is not depressed
Motor does not run
before pressing the trigger switch.
Chain brake is engaged.
Saw chain is bound in the wood.
Debris in bar groove.
Debris in side cover.
Chain does not engage drive sprocket.
Motor runs, but chain
does not rotate
Debris preventing full movement of
the chain kickback brake handle.
Chain brake does not
engage
Possible chain brake malfunction
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS1400E/CS1600E
SOLUTION
Attach the battery pack to the chain saw.
Remove the battery, check contacts and reinstall the
battery pack.
Charge the battery pack.
Allow the battery pack or chain saw to cool until the
temperature drops below 67°C.
Press down the lock-off button and hold it, then
depress the trigger switch to turn on the chain saw.
Pull the chain kickback brake handle backward
toward the front handle.
Release the trigger switch; remove the saw chain and
guide bar from the wood, then restart the chain saw.
Press the saw chain against the wood, move the
chain saw back and forth to discharge the debris.
Remove battery pack, then remove side cover and
clean out debris.
Reinstall the chain, making sure that the drive links
on the chain are fully seated on the sprocket.
Clean debris from external chain brake mechanism.
Contact EGO Customer Service.
EN
17