Troubleshooting - Ego Power+ CS1610E Manual Del Usuario

TROUBLESHOOTING

EN
WARNING:
Always protect your hands by wearing heavy gloves when performing any maintenance on the saw chain.
Always remove the battery pack when servicing or transporting the chain saw.
PROBLEM
Motor does not start.
Chain saw stops
running during working.
Motor runs, but chain
does not rotate.
Chain brake does not
engage.
12
CORDLESS CHAIN SAW — CS1610E
CAUSE
◾
The battery pack is not attached to the
chain saw.
◾
There is no electrical contact between
the saw and battery.
◾
The battery pack is depleted.
◾
The battery pack or chain saw is too
hot.
◾
Chain brake is engaged.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
The chain saw is overloaded.
◾
The battery pack or chain saw is too
hot.
◾
Saw chain is bound in the wood.
◾
Chain does not engage drive sprocket.
◾
Debris preventing full movement of the
chain kickback brake handle.
◾
Possible chain brake malfunction.
SOLUTION
◾
Attach the battery pack to the chain saw.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chain saw to cool
until the temperature drops below 67°C.
◾
Pull the chain-kickback brake handle
backward toward the front handle, arriving
at the operating position.
◾
Press the saw chain against the wood,
move the chain saw back and forth to
discharge the debris.
◾
Remove battery pack, then remove side
cover and clean out debris.
◾
Decrease the load.
◾
Decrease the load. Allow the battery pack
or chain saw to cool until the temperature
drops below 67°C.
◾
Release the variable-speed trigger switch;
remove the saw chain and guide bar from
the wood, then restart the chain saw.
◾
Reinstall the chain, ensuring that the drive
links on the chain are fully seated on the
sprocket.
◾
Clean debris from the external chain brake
mechanism.
◾
Contact EGO Customer Service for repair.