Troubleshooting - Ego Power+ CSX3000 Manual Del Operador

TROUBLESHOOTING

PROBLEM CAUSE SOLUTION
◾
The power plug of battery holster is not
attached to the chain saw.
◾
No electrical contact between the
battery holster and battery.
◾
The locking tongue is not folded up.
Motor does not start.
◾
The "ON-OFF" switch is positioned to
"OFF".
◾
Chain brake is engaged.
◾
The battery pack or chain saw is too hot.
◾
The chain saw is overloaded.
Chain saw stops running
◾
Too much bits of wood blocks the
during working.
ventilation channel.
◾
The battery pack is depleted.
◾
Debris preventing full movement of the
Chain brake does not
chain kickback brake handle.
engage.
◾
Possible chain brake malfunction.
◾
Chain oil tank is empty.
◾
No oil lubrication when The oil outlet of chain bar is blocked.
◾
cutting.
Oil solidification in low temperature.
◾
Special use angle of the machine
causing the oil in the oil tank not enter to
Low oil-indicator flashes
enter the oil pipe.
in red color or showing
◾
abnormal light while the The category and color of oil is not
oil tank filled with oil. recommended.
◾
Low oil-indicator still flashing red.
◾
The category and color of oil cannot be
identified.
Low oil-indicator does
◾
A small amount of oil still in the oil tank
not work while the oil
or oil pipe.
tank is short of oil.
◾
Low oil-indicator still not work for the
above reasons.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
SOLUTION
◾
Insert the power plug of battery holster to
the chain saw.
◾
Detach battery, check contacts and reinstall
the battery pack.
◾
Fold up the locking tongue before starting.
◾
Turn the "ON-OFF" switch to "ON".
◾
Pull the chain kickback brake paddle
backward toward the top handle, arriving at
the operating position.
◾
Cool the battery pack or chain saw.
◾
Decrease the load.
◾
Clean the dust refer to the "REMOVE DUST"
part.
◾
Charge the battery pack.
◾
Clean debris from external chain brake
mechanism.
◾
Contact EGO Customer Service for repair.
◾
Filling bar and chain lubricant.
◾
Clean up the dust in the oil outlet.
◾
Change the proper lubricating oil(suit for low
temperature).
◾
Place the chain saw flat and try again.
◾
Use the recommended translucent yellow,
translucent red or translucent oil
◾
Contact EGO Customer Service for repair
◾
Use the recommended translucent yellow,
translucent red or translucent oil.
◾
Use chain saw for a while and then observe
low oil-indicator again.
◾
Contact EGO Customer Service for repair.
CORDLESS TOP HANDLE CHAIN SAW — CSX3000
EN
13