CareFusion Smoke Check Manual De Funcionamiento página 29

For the purposes of EN 60601-1-2 the Smoke Check monitor has an essential
performance (the Smoke Check should continue to indicate a level of 11-20
p.p.m. during a test, whilst measuring gas from a 15p.p.m. CO gas bottle)
Guidance and Manufacturer's Declaration – Electromagnetic Emission
The Smoke Check is intended for use in the electromagnetic environment specified
below. It is the responsibility of the customer or the user of the Smoke Check should
ensure that it is used in such an environment
Emission Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC61000-3-2
Voltage fluctuatuins /
flicker emissions
IEC61000-3-3
Guidance and Manufacturer's Declaration – Electromagnetic Immunity
The Smoke Check is intended for use in the electromagnetic environment specified
below. It is the responsibility of the customer or the user of the Smoke Check should
ensure that it is used in such an environment
Immunity Test
Electrostatic
discharge (ESD)
IEC61000-4-2
Electrical fast
transient / burst
IEC61000-4-4
Surge
IEC61000-4-5
Compliance
Group 1
Group B
Not Applicable
(battery powered)
Not Applicable
(battery powered)
IEC 60601 test
level
± 6 kV contact
± 8 kV air
± 2 kV for power
supply lines
± 1 kV for input /
output lines
± 1 kV line(s) to
line(s)
± 2 kV line(s) to
earth
Electromagnetic Enviroment -
Guidance
The Smoke Check uses RF energy only
for its internal function. Therefore, its
RF emission is very low and is not likely
to cause any interference in nearby
electronic equipment.
The Smoke Check is suitable for use in
all establishments, including domestic
and those directly connected to the
public low-voltage power supply network
that supplies buildings used for domestic
purposes
Compliance Electromagnetic
Level Enviroment -Guidance
± 6 kV contact Floors should be wood,
concrete or ceramic tile.
± 8 kV air
If floors are covered with
synthetic material, the
relative humidity should
be at least 30%.
Not Applicable Mains power quality
should be that of a typical
(Battery
commercial or hospital
powered)and
environment.
no cables
Not Applicable Mains power quality should
be that of a typical
(Battery
commercial or hospital
Powered) and
environment.
no cables.
27