Draining The Water - Honeywell TP-SMALL Manual De Instrucciones

USE & OPERATION (CONTINUED)

DRAINING THE WATER

WARNING: Always drain and discard water collected from dehumidification.
The water is not clean and cannot be used for drinking.
1. Draining water collected in the Water Tank
The condensed water can be collected directly into the water tank. When the water tank is full, the
dehumidifier will automatically shut OFF and the
panel followed by a beeping sound.
IMPORTANT: Do not move the dehumidifier when the Water Tank is full as it will be heavy and can
cause water spillage.
1.1 Locate the water tank at the front of the dehumidifier.
Gently pull the water tank out.
1.2 Grip the handle inside the water tank and carry the
water tank to a sink to empty.
1.3 Replace the empty water tank back into the front of
the dehumidifier. Please make sure that the tank is
properly positioned. The safety feature ensures that
any misalignment of the tank and the unit will prevent
the unit from turning back on.
IMPORTANT: Improper alignment or positioning of the
water tank will cause the unit to pause operation, the
warning light on top of the dehumidifier will illuminate
followed by a beeping sound, until the water tank is fitted
properly.
NOTE: There is a Foam Float inside the water tank
that senses the water level to automatically stop
dehumidification when the water tank is full. Make sure the
Foam Float is positioned correctly inside the water tank by
ensuring it lies level with the top edge of the water tank.
DO NOT REMOVE THIS FOAM FLOAT.
indicator will illuminate on the control
1.1
1.2
EN 14
Foam Float