Checking That The Wireless Lan Setting Is Completed - Canon Color imageCLASS MF8580Cdw Guía De Configuración

8
Enter the network key .
1 Enter the network key using the numeric keys .
2 Press [OK] .
9
Select <Yes>, and then press [OK] .
10
After the <Connected .> screen is displayed,
wait until the Wi-Fi indicator stops blinking and
turns on .
Wait approximately 2 minutes after the
connection.
IP address is set during this period of time .
When an error message appears:
Press [OK] to close the screen, check whether or not
the network key is correct, and then retry the settings .
If the access point cannot be detected even after
retrying, see the following .
e-Manual "When an Error Message Appears"
To set IP address manually:
e-Manual "Setting IP Addresses"
En
6
Checking That the Wireless LAN Setting
is Completed
1
Press (Status Monitor) .
2
Select <Network Information>, and then press
[OK] .
3
Select <IPv4>, and then press [OK] .
4
Select <IP Address>, and then press [OK] .
5
Take note of the IP address .
6
Press (Status Monitor) .
7
Start a Web browser from a computer, enter
http://<IP address of the machine>/
"
address field, and then press [Enter] on your
keyboard .
8
Check that the screen of the Remote UI is
displayed .
Connection is completed if the screen is displayed.
If the screen is not displayed correctly:
e-Manual "Common Problems"
in the
"