Problem
The Set Printer IP Address dialog box
is displayed during setup
(Continued)
The Enter Password / Password
Input dialog box is displayed during
setup
"You have connected the printer to an
unsecured wireless network" is
displayed during setup
70
Troubleshooting
Possible Cause and Measures
(1)TCP/IP Setting
Select Get IP address automatically or Use following IP address. Select
Get IP address automatically to search for the target printer automatically.
If it fails, check the network settings and the network connection.
IP Address/Subnet Mask/Router
Enter each value to specify a fixed IP address when Use following IP
address is selected.
(2)Network Information
Click to display the Network Information dialog box, and confirm network
settings when your access point or your machine cannot be detected
automatically during setup for use over the network. This button is enabled
when an access point was not detected or could not be connected.
(3)Connect
Click to search for the machine with the specified settings. If the machine is
still not be detected with a specified IP address, see "Cannot connect to the
machine (the machine is not detected)" on page 66.
Note
Clicking Back displays the Access Points dialog box.
The following dialog box is displayed if an administrator password is set to the
machine which has already been set up.
Admin Password
Enter the administrator password you have set. The administrator password
consists of alphanumeric characters and is no longer than 32 characters. The
password is case sensitive.
For security, your entry will be displayed by "*" (asterisks) in Windows and "•"
(bullets) in Macintosh.
The encryption settings are not configured on the access point.
The machine can still be used, so continue the setup procedure to complete it.
Important
If you connect to a network that is not protected with security measures, there is
a risk of disclosing data such as your personal information to a third party.
(1)
(2)
(3)