Leggett & Platt Symmetry SM Guía De Preparación página 6

!
WHEN INSTALLING ADJUSTABLE BASE ON
PLATFORM OR SLAT BED, MAKE SURE THE
PLATFORM OR SLAT BED CAN PROVIDE PROPER
SUPPORT FOR THE RECOMMENDED MAXIMUM
WEIGHT OF THE ADJUSTABLE BASE.
STEP 9
FOR CASE GOOD/PLATFORM SETUP (not using legs), rotate base over and place
on case good or platform.
NOTE: WHEN PLACING BASE ON CASE GOOD OR PLATFORM, DO NOT ROUTE
POWER CORDS THROUGH CASE GOOD OR PLATFORM STRUCTURE. POWER
CORDS MUST NOT INTERFERE WITH ANY BASE MECHANISMS.
STEP 10
FOR STANDALONE SETUP (using legs), install legs.
STEP 10a
Unscrew and remove (2) caps at
one end of base frame (FIGURE 7).
Screw (4) legs into the tapped
holes at the corners of the base
frame (FIGURE 7).
STEP 10b
Screw (2) legs at the hinges in
diagonal position across the
center fold of base (FIGURE 7).
STEP 10c
Rotate base over onto its legs.
6
WARNING
SETUP
DUE TO RISK OF INJURY, TWO ADULTS ARE
REQUIRED TO HANDLE AND MOVE ADJUSTABLE
CENTER LEGS
INSTALLED
DIAGONALLY
FIGURE 7
DISPOSE OF CAPS AFTER REMOVAL (FIGURE 7).
WARNING
!
BASE.
2 CAPS (UNSCREW
AND DISPOSE OF
CAPS)
WARNING
!
CHOKING HAZARD!