Product Features; Important Safety - Tripp-Lite B002A-DP2A2 Manual Del Propietário

Product Features

• Certified to NIAP/Common Criteria Protection Profile for Peripheral Sharing Switches, Version 3.0.
• Safely switch between as many as 8 computers with varying security levels.
• Support connection of Common Access Cards (CAC), biometric readers and other smart card readers (select models only).
• Support 4K video resolutions up to 3840 x 2160 @ 30 Hz.
• Anti-Tampering Protection: Internal anti-tamper switches disable the KVM if the housing is opened. While disabled, front-
panel LEDs will flash repeatedly. Opening the housing also voids the warranty.
• Tamper-Evident Seals: Provide visual evidence if the KVM has been tampered with or compromised. Removing these labels
voids the warranty.
• Protected Firmware: Prevents reprogramming or reading firmware, protecting against attempts to alter the KVM's logic.
• High Isolation on USB Channels: Opto-isolators keep USB data paths electrically isolated from each other, preventing data
leakage between ports.
• Secure EDID Learning and Emulation: Prevents unwanted and unsecure data from being transmitted through the DDC line.
• Automatic Keyboard Buffer Clearing: Keyboard buffer is cleared automatically after data transmission, so no information is
left stored in the KVM.
• No Memory Buffer: The only access to connected computers is via push button. Port-switching methods such as OSD and
hotkeys are excluded to ensure data integrity.
Important Safety Instructions
• Read all instructions and save them for future reference.
• Follow all warnings and instructions marked on the device.
• Do not place the device on any unstable surface (cart, stand, table, etc.). If the device falls, serious damage will result.
• Do not use the device near water.
• Do not place the device near or over radiators or heat registers. The device cabinet contains slots and openings to allow for
adequate ventilation. To ensure reliable operation and to protect against overheating, these openings must never be blocked
or covered.
• The device should never be placed on a soft surface (bed, sofa, rug, etc.), as this will block its ventilation openings.
Likewise, the device should not be placed in a built-in enclosure unless adequate ventilation has been provided.
• Never spill liquid of any kind on the device.
• Unplug the device from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
• The device should be operated from the power source type as indicated on the marking label. If you are not sure of the type
of power available, consult your dealer or local power utility.
• Do not allow anything to rest on the power cord or cables. Route the power cord and cables so that they cannot be stepped
on or tripped over.
• If an extension cord is used with this device, make sure the total ampere rating of all products used on the cord does not
exceed the extension-cord ampere rating. Make sure the total rating of all products plugged into the wall outlet does not
exceed 15 amperes.
• Position system cables and power cables carefully. Make sure nothing rests on any cables.
• To help protect your system from sudden transient increases and decreases in electrical power, it is recommended you plug
your devices into a Tripp Lite surge protector, line conditioner or uninterruptible power supply (UPS).
4