Miscellaneous Kvm Functionality; Disabling Cac Functionality; Enabling Cac Functionality; Cac Port Configuration - Tripp-Lite B002A-DP2A2 Manual Del Propietário

Miscellaneous KVM Functionality

Note: The following steps are intended for the system administrator only.

Disabling CAC Functionality

To disable CAC for any port on the KVM (all CAC ports are enabled as default), use the front-panel push buttons to switch the
KVM to the port whose CAC mode you wish to change. Once selected, the push-button LED for the selected port will illuminate
blue to indicate CAC functionality is enabled. Press and hold the button for 3 seconds until the blue push-button LED turns off.
CAC functionality for the port is now disabled.

Enabling CAC Functionality

To enable CAC for any port on the KVM switch, use the front-panel push buttons to switch the KVM to the port whose CAC
mode you wish to change. Once selected, the push-button LED for this specific channel should be off to indicate CAC
functionality is disabled. Press and hold the button for 3 seconds until the blue push-button LED turns on. CAC functionality for
the port is now enabled.

CAC Port Configuration

CAC port configuration is an optional feature, allowing registration of any USB peripheral to operate with the KVM. Only one
peripheral can be registered at a time, and only the registered peripheral will be able to operate with the KVM. If a peripheral
other than the registered peripheral is plugged into the USB-A CAC port, it will not work. When no peripheral is registered, the
KVM will default to operate with any CAC Reader. To configure the USB-A CAC port, follow the instructions below:
Note: Only one computer connected to port 1 is required for this operation.
1. Open the Administration and Security Management Program (see the EDID Learn section for download instructions). The
Administration and Security Management screen will appear.
2. Initiate the session by pressing the following hotkey command, one key after another:
[Alt][Alt][c][n][f][g]
3. Upon completing the command, the mouse connected to the KVM will stop functioning. A prompt will appear to enter the
Credential ID.
4. Log in by entering the default username admin and pressing Enter.
5. Enter the default password 12345 and press Enter.
6. Select option 2 from the menu on your screen and press Enter.
7. Connect the USB peripheral device to be registered to the console USB-A CAC port on the KVM. Wait until the KVM is
reading the new peripheral information.
9