Edid Learn - Tripp-Lite B002A-DP2A2 Manual Del Propietário

EDID Learn

KVM models with HDMI video output are designed to learn the connected monitor's EDID upon power-up. When a new monitor
is connected to the KVM, a power cycle is required. To indicate to the user that the EDID learn process is occurring, the front
panel's green Port LEDs and blue push-button LEDs will flash for about 10 seconds.
For dual-monitor KVM models, the unit will learn the EDID of the second connected monitor after the first monitor's EDID has
been read. The front-panel LEDs will flash to indicate the process is taking place. When the front-panel LEDs stop flashing, the
EDID learning process is complete.
KVM models with DisplayPort video output use built-in EDID information that is set to HD resolution (1080p maximum), which
will allow initial operation with most DisplayPort monitors. For security purposes, EDID learning of DisplayPort displays can
be performed only by an Authenticated Administrator. Follow the steps below to perform EDID learning on your DisplayPort
monitor:
1. This process should be started with a powered-off KVM and computer that are not connected to each other.
2. Connect a DisplayPort cable between the computer's DisplayPort output and the KVM's Port 1 DisplayPort input.
3. Using a USB A/B device cable, connect an available USB port on the computer to the KVM's Port 1 USB-B port.
4. Connect a DisplayPort monitor to the console video output port of the KVM using a DisplayPort cable.
5. Connect a wired USB keyboard and mouse to the console USB keyboard and mouse ports of the KVM.
Note: Keyboards and mice with internal USB hub or composite device functions are not supported. Wireless keyboards and mice are not
supported.
6. Power on the computer and KVM switch.
7. From the connected computer, download the Administration and Security Management Tool from tripplite.com/support.
8. Once downloaded, run the Administration and Security Management Tool executable file. The Administration and Security
Management screen will appear.
9. Initiate the session by pressing the following hotkey command, one key one after another:
[Alt][Alt][c][n][f][g]
10. Upon completing the command, the mouse connected to the KVM will stop functioning. A prompt will appear to enter the
Credential ID.
11. Log in by entering the default username admin and pressing Enter.
12. Enter the default password 12345 and press Enter.
13. Seven options will appear in a numerical menu. Select option 6 and press Enter.
14. A menu will appear prompting you to Select Mode. Type local and press Enter. The Administration and Security
Management Tool will automatically learn and store the display's EDID. The device will then reset and reboot. At the end
of the boot-up, ensure all connected computers are properly displaying video on the connected monitor.
8