Lorex E881AP Serie Guia De Inicio Rapido página 11

Step five.
1. Connect the connection cables.
To connect the cables using the waterproof connector (see Figure 6):
a. Fit the o-ring around the camera Ethernet connector.
b. Feed the Ethernet extension cable through the end cap and the barrel then connect the cable
to the camera Ethernet connector.
c. Twist the barrel securely onto the camera Ethernet connector. The o-ring becomes
compressed when the seal is properly tight.
d. Split the stopper to wrap it around the cable between the barrel and end cap as shown above.
e. Push the stopper toward the barrel until it is underneath the teeth at the end of the barrel.
f. Twist the end cap clockwise to secure it onto the barrel. The stopper becomes compressed
and will stick out of the end cap slightly when the seal is properly tight.
O-ring
Camera Ethernet connector
Figure 6
Stopper
Barrel
End cap