Safety Precautions - Lorex E881AP Serie Guia De Inicio Rapido

Safety precautions

3
• Make sure to disconnect the power cabling before installing the camera. Camera will begin moving
immediately when power cable is connected.
• Make sure to install the camera in a location that can support the combined weight of the camera
and wall mount (weight: 11.7lb/5.3kg).
• Make sure to secure the camera during installation by connecting the included safety chain.
• Camera is rated for outdoor use. It is recommended to install the camera in a sheltered area, such
as under the eaves on a roof.
• It is recommended to install the camera as high up as possible to get the best possible image.
• Mount the camera where the lens is away from direct and intense sunlight.
• Mount the camera in an area that is visible but out of reach.
• Ensure that the camera wiring is not exposed or easily cut.
• Plan your cable wiring so that it does not interfere with power lines or telephone lines.
• Ensure you adhere to local building codes.
Attention: A REGULATED UL / CSA APPROVED power supply is REQUIRED for use with this
camera (included). Use of a non-regulated, non-conforming power supply can damage this
product and voids the warranty.