Axxess AX-TOYCAM2 Instrucciones De Instalación

Installation Instructions for AX-TOYCAM2
AX-TOYCAM2
Toyota Back-Up Camera Retain/Add-On
2006-2013
• Retains the factory back-up camera to an aftermarket radio
• Allows an aftermarket camera to be added to the factory screen*
* Display and navigation model radios only
INTERFACE COMPONENTS
• AX-TOYCAM2 harness
APPLICATIONS
TOYOTA
4-Runner 2012-2013
(with a factory amp)
4-Runner 2006-2011
Avalon 2011-2012
Camry 2007-2011
Highlander 2008-2012
TOOLS REQUIRED
• Cutting tool • Tape • Crimping tool
• Connectors (example: butt connectors, bell caps, etc.)
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator lights
must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
® axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 1/30/17 © COPYRIGHT 2004-2017 METRA ELECTRONICS CORPORATION
FEATURES
Prius
Sienna
Sequoia
(with a factory amp)
Tundra
(with a factory amp)
Venza
(with NAV)
Installation Instructions for AX-TOYCAM2
The AX-TOYCAM2 can be connected two different ways
To retain the factory back-up camera to an aftermarket radio:
• Connect the Black wire to chassis ground.
• Connect the Yellow wire to accessory power. *
• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle.
• Disregard the loose Green/Purple wire, it will not be used in this application.
* It is highly recommended to use the AX-CAM6V (sold separately) to provide the camera
with the proper voltage.
To allow an aftermarket camera to be added to the OEM screen:
• Connect the Black wire to the ground wire of the aftermarket camera.
• Connect the power wire of the aftermarket camera to accessory power.
• Tape off and disregard the Yellow wire, it will not be used in this application.
• Connect the female Yellow RCA jack to the aftermarket camera.
2010-2011
The following (2) steps are only required if a
2008-2010
wire is not present in the factory harness.
2008-2012
2007-2013
•
If a wire is not present in pin-5 of the
2009-2012
5-pin connector of the factory radio,
unplug the connector, then insert the metal
pin of the loose Green/Purple wire into it.
Connect the harness back into the radio
• Connect the other end of the loose
Green/Purple wire to the reverse
wire of the vehicle.
®
REV. 1/30/17
Connections to be made
.
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
axxessinterfaces.com • metraonline.com
Axxess Integrate
© COPYRIGHT 2004-2017 METRA ELECTRONICS CORPORATION
5 Pin Harness
1 2 3 4 5
This is the wire view of the
connector in the vehicle
Metra recommends MECP
certified technicians