Installation And Transportation; Receiving The Machine; Lift And Transportation; Removal From Packing - AT-OS AF2 P-LINE Instrucciones Operativas

Tel. ++39 045 6159411- Fax ++39 045 6159422 - e-mail: info@at-os.com – www.at-os.com
8

INSTALLATION and TRANSPORTATION

Receiving the machine

When receiving the machine always immediately check that all the material listed on shipping documents has been received. Also
check that the machine has not been damaged. If it has been damaged then you must contact the shipper and the AT-OS S.r.l.
customer service office within two days, informing them of the amount of damage. Reimbursement will only be possible when you
act quickly and in due time.
8.1

Lift and Transportation

To transport the machine just pack it, fully assembled, and then give it to specialized personnel with the necessary handling
equipment.
Transportation of the packed machine is done by performing precise hoisting and positioning procedures:
•
to hoist the machine use a lift truck that acts on the bottom side of the wooden pallet that is securely fastened to the rest of the
packing and constitutes the packing base:
INSERT ZONE FOR
LIFT TRUCK FORKS
•
each movement of the packed machine must be done giving special attention to avoid brusque swinging (maintaining a
horizontal position).
Important: Always refer to the guidelines given on the packing (indication of the top side of the packing, do not expose in damp or
wet sites, protect against weather. Do not stack more than "N" equal packed appliances and handle the contents of the packing with
care). Whenever it is necessary to handle the machine always proceed to repack it in compliance with all the instructions given in the
various sections of this manual.
8.2

Removal from packing

Remove the machine from its packing after placing it in the vicinity of its installation site. The opening of the packing is located on its
top side (cardboard packing). Otherwise you must unscrew all the screws on the sides of the crate (wooden crate). Packing must not
be left within the reach of children (bags, polystyrene, etc.) because they could be ingested and be a source of danger.
We recommend preserving packing for eventual reshipment, handling and reinstallation, at least until such time as the appliance is
tested. Check to make sure that good materials are not thrown away together with unused packing materials.
8.3

Installation

The following characteristics are specified when the terms "main switch", "drain" (Fig. J page IV appendix I), and "supply cocks" (Fig.
L page IV appendix I) are used in this manual.
8.3.1

Main switch

The main switch must be a multi-pole circuit breaker that interrupts all contacts, including neutral. The distance between contacts
must be at least 3 mm with magneto thermal safety tripping or combined with fuses and able to support the maximum current levels
indicated on the machine's identification plate (also refer to current laws and codes).
The circuit breaker or fuses must be set according to the power rating indicated on the machine's identification plate.
Correct switch positioning is indicated on the installation diagram.
Viale del Lavoro, 19 37030 Colognola ai Colli (Verona) Italy
AT-OS S.r.l. recommends installing its machine by connecting the electrical supply to
these devices. this will protect the safety of machine operators and all those who come
in contact, even accidentally, with the appliances in question.
AT-OS S.r.l.
COVER (WOODEN CRATE or
CARDBOARD PACKING)
MACHINE
PALLET
34