Alarm Messages - AT-OS AF2 P-LINE Instrucciones Operativas

Tel. ++39 045 6159411- Fax ++39 045 6159422 - e-mail: info@at-os.com – www.at-os.com

13.5 Alarm messages

The machine is programmed to give alarm messages when it is operating.
Here is an example of two lines of alarm message on the display (see paragraph 11.2.1 "Display")
In the following table the "Alarm" column indicates the message that appears on the first and second line of the machine's display
and the "Malfunction" column gives the cause that generated the message:
Alarm
Alarm
E00: PTC Probe Break
Alarm
E01: PTC Probe Short C
Alarm
E02: No PTC Connected
Alarm
E03: Plumb.Syst.Probl
Alarm
E04: Detergent Empty
Alarm
E05: Solvent Empty
Alarm
E10: Water not Filled
Alarm
E11: Low W. Lev. Off
Alarm
E12: Door timeout
Alarm
E13: Door overloading
Alarm
E14: Door Sensor ERR.
Alarm
E15: Manual Interrup.
Alarm
E16: No washing
Alarm
E17: Softener Supply
Alarm
E18: Detergent Supply
Alarm
E20: NO Disinfection
Alarm
AT-OS S.r.l.
Viale del Lavoro, 19 37030 Colognola ai Colli (Verona) Italy
Malfunction
Displayed if a supply cable for a temperature probe (PTC) in the wash basin is
cut off.
Displayed if a temperature probe (PTC) in the wash basin is shorted.
Displayed if no temperature probe (PTC) as enabled to operate.
Displayed when there are plumbing problems (solenoid valves and/or tubes
clogged or pump broken) that prevent water from exiting from the storage tank.
Displayed when detergent is finished (the empty drum must be replaced with a
drum filled with the same liquid).
Displayed when solvent is finished (the empty drum must be replaced with a
drum filled with the same liquid).
Displayed when the water level in the storage tank is not reached within a
preset time period.
Displayed when there are operating problems with the level probes installed in
the water storage tank (broken, disconnected or dirty).
Displayed when there are problems opening/closing the door that cause a
substantial delay in performance of this procedure.
Displayed when the stress performed by the door open/close motor is greater
than the safety level: generally caused by objects that prevent the door from
opening/closing.
Displayed when there are problems with the magnetic door closed sensor
which is either disconnected or damaged.
Displayed when the "Reset" key is pressed while the machine is in stand-by or
when the door is opening/closing.
Displayed at the end of the washing phases, in the case that the water level inside the
storage tank has not gone down the level probe yet.
Displayed if the maximum time period necessary to put the anti-scale liquid is
exceeded.
Displayed if the maximum time period necessary to put the detergent is exceeded.
Displayed if the machine is not able to maintain the disinfecting temperature for
the preset time period and consequently disinfecting has not taken place.
Displayed when the maximum time period necessary to load water into the
48
What to do