Turning On The Power; Auto Standby - Yamaha MusicCast WX-030 Manual De Instrucciones

Rear pannel
Top pannel
Tap (power)/CONNECT.
Power indicator

TURNING ON THE POWER

Power cable
A Plug the power cable into the wall outlet
and tap (power)/CONNECT.
The unit turns on and the power indicator lights. If
you tap again, the unit turns off (standby mode)
and the power indicator turns off.
y Auto Standby
Auto Standby is a mode in which the unit
automatically enters standby mode if about
20 minutes have elapsed with no playback and no
operation. You can enable/disable this mode with
the MusicCast CONTROLLER app (☞ P.7).
Note
• After the power plug is inserted to the wall outlet, it takes
about 10 seconds for the unit to start up internally. The
unit cannot play back during this time.
• Do not touch the touch sensors (
CONNECT/ / /
the unit starts up, since the unit is adjusting sensor
sensitivity. If your finger touches the touch sensors during
this time, they may not function properly after the unit
starts up.
(power)/
) for about 10 seconds after
5
En