Lexmark OptraImage Guia De Instalacion página 10

Germany: Use only the German TAE
type F adapter (P/N 14B5123) shipped
with this product because it contains a
billing tone filter. The adapter is
designed only for the F connector of the
German wall outlet. This must be the
only device attached to the NFN wall
receptacle. Switzerland: Use only the
Swiss adapter (P/N 14B5109) shipped
with this product because it contains a
billing tone filter.
Telephone fax
line cable
(RJ-11)
Ethernet
network cable
SCSI cable
Automatic document
feeder cable
Correct SCSI
switch settings
8
Telephone fax cable
To send or receive faxes, you must plug the RJ-11 telephone
fax line cable into the fax modem port of the back on the
MarkNet N2501e print server installed in your printer.
If you received a telephone adapter specifically designed for
use in your country, attach the telephone adapter to the
telephone fax line cable. Do not plug the fax telephone cable
into the wall outlet yet.
Network cable
If you want to be able to send network print jobs to your
OptraImage printer, plug the Ethernet cable into the Ethernet
network port on the back of the MarkNet print server installed
in your printer.
SCSI cable
Automatic document feeder cable
Power adapter cable
In order for the automatic document feeder to function, you
must plug the automatic document feeder cable into the
corresponding port on the back of the scan unit.
Power cords
Connect all the power cords to the scan unit and the printer,
but do not turn the power on yet.
SCSI cable
The SCSI cable connects your scan unit and printer to each
other. Connect the SCSI cable in this step, but do not turn
the power on yet.
Make sure the SCSI switch settings on the back of the scan
unit are in the correct position.
OptraImage Setup Guide