Vehicle Preparation; Installation Procedure - Mopar 82211438 Serie Instrucciones De Instalación

1. Lower one or more of the passenger windows so the keys do not get locked in the ve-
hicle.
2. Disconnect and isolate the negative battery cable. The battery will need to be
re-connected before programming.
3. Locate and cut provided new keys prior to remote start installation.
TOOLS REQUIRED
KIT CONTENTS
This instructional manual will discuss the installation of the hood switch harness & XBM
(Remote Start) turn-on. Other steps will include replacement procedure of the WCM,
antenna installation, hood switch installation, and uploading of vehicle configuration from
Dealer Connect. Refer to the vehicle Service Manual for specific installation procedures
for all components except the hood switch harness, which is covered here in detail.
Hood Switch Installation
1. Refer to the vehicle Service Manual section 8 Electrical/
Vehicle Theft Security/Hood Ajar Switch/Installation - for
Hood Switch installation.
Disconnect Ground From Battery
1. Remove ground from battery
a. Using a 10mm socket remove the negative battery cable.

VEHICLE PREPARATION

10mm
1X
12X
2X
2X

Installation Procedure:

1/4"
1X
1X
OVERVIEW
2 of 9
T-20
2X
1X