Mopar 82211438 Serie Instrucciones De Instalación página 6

4. Reinstall the TIPM
a. Reinstall TIPM onto the mounting location.
b. Reinstall battery connection to the TIPM.
5. Connect hood switch harness ground
a. Locate the PCM mounted on the passenger
side fender.
b. Remove the bottom 8 mm bolt. Place the
hood switch harness ground terminal over the 8
mm bolt and reinstall.
WCM Replacement
** Orginal WCM must be removed and the new WCM must be installed **
1. Refer to the vehicle Service Manual section 8 Electrical/
Starting/Remote Start Antenna Module/Installation - for
WCM replacement.
Positive Battery Feed
Ground Location
6 of 9
TIPM Mounting tabs