Mopar 82211438 Serie Instrucciones De Instalación página 4

2. Access the connectors underneath the TIPM
a. Using a 13 mm socket, remove the positive battery feed
to the TIPM.
b. Access connectors at the bottom of the TIPM by releasing
the (4) tabs in the corners of the TIPM and lifting upward.
3. Connect the hood pin switch wire
a. Unplug the "D" connector from the TIPM.
b. Remove the "Secondary Lock" from the rear of the
connector.
c. Remove the weather seal from the rear of the connector.
Positive Battery
Feed
"D" connector
"Secondary Lock"
Weather Seal
4 of 9
TIPM Mounting tabs