Checklist When Data Is Missing On The Display; Setting The Time And Date Manually - ADE DCF-Funkuhr CK 1927 Instrucciones De Operación

Checklist when data is missing on the display

No data display from the time signal transmitter
1. Check whether the location of the radio-controlled clock is suitable, see
"Choosing a location".
2. Restart reception manually, see "Manually starting signal reception".
3. Wait until the radio-controlled clock automatically switches to receiving mode at
a later point in time. The reception is usually better at night.
4. Manually perform the settings if reception is not possible at your location, see

"Setting the time and date manually".

Setting the time and date manually
‚ If there is more than approx. 20 seconds between two pushes of a
button, the setting process automatically ends and you will have to
repeat it.
‚ If you press and hold the
increased or decreased more quickly.
1. Press and hold down the
2. Use the or button to set whether a beep should follow each press of a button
("ON" = default setting) or switch this function off ("OFF").
3. Press in order to save the settings. "00" flashes in the display for the time zone
you are in ("00" is the default setting for the European mainland).
4. Proceed as previously described:
− Press the
or
− Press
to save a setting.
5. You should set the following:
− Hours
− Minutes
− Year
− Month
− Day
− Language (relates exclusively to the weekday indicator)
6. Finally, press
CK 1927 XL radio-controlled wall clock
button until "BEEP ON" appears on the display.
button to set the desired value.
to conclude the procedure.
or buttons, the displayed values will be
Receiving the time signal
23